BobCat 753 – CONTROL PEDALS – Removal And Installation

Remove the bolt (Item 1) [Figure 50-90-1] and nut from the pedal linkage.

Installation: Tighten the bolt and nut to 25-28 ft.-lbs. (34-38 Nm) torque.

Check the rubber bushing in the pedal for wear and replace as needed.

Remove the two mounting bolts (Item 1) [Figure 50-90-2] from the pedal mounting bracket.

Remove the pedal assembly from the loader.


Leave a Reply

Your email address will not be published. Required fields are marked *