BobCat 753 – CONTROL HANDLE – Shaft Removal And Installation

NOTE: The steering shaft can be removed without removing the control panel from the loader. Photo [Figure 50-                      110-2] shows the control panel removed for clarity purpose only.

Remove the steering linkage mounting bolts (Item 3) [Figure 50-110-1].

Remove the steering shock mounting nuts (Item 2) [Figure 50-110-1].

Remove the steering shaft pivot bolt (Item 1) [Figure 50-110-2] from both sides of the control panel.

Installation: Tighten the pivot bolts to 180-200 in.-lbs. (21-23 Nm) torque.

Remove the steering shaft from the control panel.


Leave a Reply

Your email address will not be published. Required fields are marked *