BobCat 753 – CONTROL HANDLE (ADVANCED CONTROL SYSTEM) (ACS) ADVANCED HAND CONTROL – Control Handle Removal and Installation

Remove the handle sensor (Item 1) [Figure 50-113-15].
(See Handle Sensor Removal And Installation on Page 50-113-1.)

Remove the switch handle (Item 1) [Figure 50-113-16].
(See Switch Handle Removal on Page 60-123-6.)

Remove the rubber handle cover (Item 1) [Figure 50-113-17] from the handle.

Using a small screwdriver, hold the handle spacer (Item 1) and remove the allen head screws (Item 2) [Figure 50-113-18] from the handle assembly.

Installation: Tighten the allen head screws to 35 in.-lbs. (4 Nm) torque.

 

Leave a Reply

Your email address will not be published. Required fields are marked *