BobCat 753 – CHARGE PRESSURE – Checking Charge Pressure

Lift and block the loader. (See LIFTING AND BLOCKING THE LOADER on Page 10-10-1.)

Open the rear door.

Disconnect the wires (Item 1) [Figure 30-30-1] from the charge pressure sender.

Remove the charge pressure sender (Item 2) [Figure 30-30-1] from the fitting.

Installation: Tighten the mounting bolts and nuts to 15 ft.-lbs. (20 Nm) torque.


Leave a Reply

Your email address will not be published. Required fields are marked *