BobCat 753 – CHAINCASE – Rear Cover Removal And Installation

Disconnect the front steering linkage bars from the rear linkage bars. (See Linkage Removal And Installation on
Page 50-110-3.)

Move the linkage bars to allow adequate space to remove the rear chaincase cover.

Remove the front auxiliary bleed block, if equipped. (See Removal And Installation (S/N 515842309 and Below) on Page 20-120-1.)

Remove the eight rear chaincase cover mounting bolts (Item 1) [Figure 40-30-8].

Installation: Tighten the mounting bolts to 25-28 ft.-lbs. (34-38 Nm) torque.

Remove the rear chaincase cover (Item 2) [Figure 40-30-8] from the loader.

Installation: The rear chaincase cover (Item 2) [Figure 40-30-8] has a gasket (Item 1) [Figure 40-30-9] installed
between the cover and the chaincase. Install a new gasket if necessary. (See Linkage Neutral Adjustment on Page 50-110-8.)

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *