BobCat 753 – CHAINCASE – Front Cover Removal And Installation

Raise the loader lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.)

Raise the loader operator cab. (See Raising The Operator Cab on Page 10-30-1.)

Remove the brake pedal (If equipped) (Item 1) [Figure 40-30-4]. (See Pedal Removal And Installation (S/N
515834999 & Below) on Page 40-10-1.).

Remove the eight front chaincase cover mounting bolts (Item 1) [Figure 40-30-5].

Installation: Tighten the mounting bolts to 25-28 ft.-lbs. (34-38 Nm) torque.

Remove the front chaincase cover (Item 2) [Figure 40-30-5] from the loader.

Installation: The front chaincase cover (Item 2) [Figure 40-30-5] has a gasket installed between the cover and
the chaincase. Install new gasket if necessary.


Leave a Reply

Your email address will not be published. Required fields are marked *