BobCat 753 – CHAINCASE – Center Cover Removal And Installation

Disconnect and remove the engine speed control from the control panel. (See Removal And Installation on Page 70-20-1.)

Remove the control panel from the loader. (See Removal and Installation on Page 50-100-1.)

Disconnect the lift control cross bar (Item 1) [Figure 40-30-6] from the lift pedal linkage.

Disconnect the lift control cross bar (Item 2) [Figure 40-30-6] from the lift spool on the main control valve.

Disconnect the electrical connector (Item 3) [Figure 40-30-6] & [Figure 40-30-7] from the parking brake pedal sensor.

Remove the ten center chaincase cover mounting bolts (Item 4) [Figure 40-30-6] and [Figure 40-30-7].

Installation: Tighten the mounting bolts to 25-28 ft.-lbs. (34-38 Nm) torque.

Remove the center chaincase cover from the loader.

Installation: The center chaincase cover has a gasket installed between the cover and the chaincase. Install new gasket if necessary.


Leave a Reply

Your email address will not be published. Required fields are marked *