BobCat 753 – BRAKE – Pedal Removal And Installation (S/N 515834999 & Below)

Raise the loader operator cab. (See Raising The Operator Cab on Page 10-30-1.)

Remove the two mounting bolts (Item 1) [Figure 40-10-5] from the brake pedal mounting bracket.

Disconnect the electrical connector from the parking brake pedal sensor. The connector is located behind the control panel.

Installation: Tighten the mounting bolts to 25-28 ft.-lbs. (34-38 Nm) torque.

Remove the fuse mount bracket (Item 1) [Figure 40-10-6] from the front of the control panel.

Remove the parking brake assembly from the loader.

Reverse the removal procedure to install the parking brake assembly in the loader.


Leave a Reply

Your email address will not be published. Required fields are marked *