BobCat 753 – BOBCAT CONTROLLER – Removal And Installation

Lift and block the rear of the loader. (See LIFTING AND BLOCKING THE LOADER on Page 10-10-1.)

Raise the lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.)

Stop the engine. Raise the seat bar.

Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.)

Loosen the connector mounting bolts (Item 1) [Figure 60-70-1] and [Figure 60-70-2] from the bobcat controller.

Remove the connectors.

NOTE: The connectors are keyed and will only plug in one way.

Remove the three mount bolts (Item 1) [Figure 60-70-3] of the system controller mounting bracket.

Remove the system controller.

Installation: Tighten the nuts to 25-28 ft.-lbs. (34-38 Nm) torque.


Leave a Reply

Your email address will not be published. Required fields are marked *