BobCat 753 – ALTERNATOR (90 AMP) – Disassembly

Disassemble the alternator [Figure 60-31-17].

Remove the regulator cover.

Remove the four bolts holding halves together.

Pry the halves apart (use a press if needed).

Use a soft jaw vise to hold rotor while removing pulley nut.

Remove front case half from the rotor using a plastic hammer or press.

Unsolder the stator leads from the rectifier. Remove the stator.

Unsolder the two leads between the rectifier and regulator. Remove the regulator from rectifier.

 

Leave a Reply

Your email address will not be published. Required fields are marked *