BobCat 753 – AIR CLEANER – Removal And Installation

Disconnect the wire harness connector (Item 1) [Figure 70-40-1] from the air cleaner sensor on the air cleaner.

Loosen the hose clamp (Item 1) [Figure 70-40-2] on the air cleaner hose.

Loosen the clamp (Item 2) [Figure 70-40-2] from the hose on the engine manifold.

Remove the lower mounting bolt (Item 1) and engine harness mounting bracket (Item 2) [Figure 70-40-3] from the air cleaner.

Remove the two upper mounting bolts (Item 3) [Figure 70-40-2] from the top mount of the air cleaner.

Installation: Tighten the three mounting bolts to 25-28 ft.-lbs. (34-38 Nm) torque.

Remove the air cleaner from the engine compartment.

Reverse the removal procedure to install the air cleaner.


Leave a Reply

Your email address will not be published. Required fields are marked *