BobCat 753 – ADVANCED HAND CONTROL (AHC) SYSTEM (W/ PUSH BUTTON FLOAT) – AHC Controller Removal And Installation

Remove the control panel from the loader. (See Removal and Installation on Page 50-100-1.)

Disconnect the wiring harness connectors from the controller (Item 1) [Figure 60-121-5].

Remove the two mounting bolts (Item 1) [Figure 60-121-6] from the controller mounting bracket.

Remove the controller from the loader.

Remove the four mounting bolts (Item 2) [Figure 60-121-6] from the controller.


Leave a Reply

Your email address will not be published. Required fields are marked *