BobCat 753 – ADVANCED HAND CONTROL (AHC) SYSTEM – Control Handle Unit Connector

The wire connector (Item 1) [Figure 60-120-7] can be removed from the handle control unit wires, use the following procedure.

Remove the wedge (Item 1) [Figure 60-120-8] from the connector.

With a pointed tool, lift the tab (Item 1) [Figure 60-120-9] and pull the wire from the connector.
Assembly: Install the wires into the connector as listed below [Figure 60-120-9]:
1-Terminal – Red
2-Terminal – Black
3-Terminal – Green


Leave a Reply

Your email address will not be published. Required fields are marked *