BobCat 753 – ADVANCED CONTROL SYSTEM (ACS) SELECTABLE HAND/FOOT CONTROL – Handle Lock Solenoid Removal And Installation

Disconnect the harness connector (Item 1) [Figure 60-123-31] from the handle sensor connector.

Disconnect the harness connector (Item 2) [Figure 60-123-31] from the handle lock solenoid connector.

Remove the two screws (Item 1) [Figure 60-123-32] holding the handle lock solenoid to the handle.

Installation: Tighten the screws to 32-38 in.-lbs. (3,6-4,3 Nm) torque.

Remove handle lock solenoid assembly from handle.


Leave a Reply

Your email address will not be published. Required fields are marked *