BobCat 753 – ADVANCED CONTROL SYSTEM (ACS) SELECTABLE HAND/FOOT CONTROL – Foot Sensor Disassembly And Assembly

Remove the two bolts (Item 1) [Figure 60-123-47] from the end of the foot sensor.

Installation: Tighten the bolts to 90 in.-lbs. (10,2 Nm) torque. Apply LOCTITE 242 to the threads.

Remove the boot retainer (Item 1), boot (Item 2), spool stop plate (Item 3), O-ring (Item 4) [Figure 60-123-48].

NOTE: Do not disassemble the sensor assembly (Item 5) [Figure 60-123-48]. The sensor assembly is a calibrated assembly and cannot be serviced. Order through Bobcat Parts.

 

Leave a Reply

Your email address will not be published. Required fields are marked *